No results were found for the filter!
Internal turning tool, round, made of particularly hard special steel including brass insert for secure clamping. Diameter: 2,00 mm Diameter: 4,00 mm
€23.00 *
Tungsten tip, 1 piece, for refill, for our tourning tools 41617 to 41719.
€10.90 *
Replacement screw Torx M2.5 x 5 / T08 made of special steel for turning tools with tungsten tip.
€5.30 *
Tungsten tips, ground model, for our tourning tools 41617 to 41719. With these tungsten tips you can achieve an especially fine surface.
€12.90 *
Tungsten tip (right 7°, 1.0 mm) for refill for steel (Tool holder no. 41623-S sold out) Tungsten tip (right 7°, 1.0 mm) for refill for brass (Tool holder no. 41623-M sold out)
€37.00 *
Set of drive belts for your UNIMAT 3+4. Set consists of 2 drive belts ZOR 50 6333, 2 drive belts ZOR 50 6336, 1 drive belt ZOR 50 6222.
€6.90 *
Pad foil band (4 pcs.), 13 mm wide each and about 200 mm long, thickness 0.1 – 0.2 – 0.5 – 1.0 mm. Foil bands are for example used for aligning of turning tools in tool holders. According to capacity of your tool holder 3 - 4 tool pads...
€6.70 *
Small parting tool holder (idea: Detlef Beier). Measurements 6 x 6 x 65 mm including thin, just 0.5 mm wide parting-off-blade for soft metals. One side with straight cut for brass, other side with curved cut for soft steel, alu-minium...
€25.00 *
Cutting tools 8 x 8 x 80 mm out of very hard special steel. Pointed cutting tool Side cutting tool, right Side cutting tool, left Rough cutting tool, right Cutting tool Interior turning tool, 140 mm
€14.90 *
Cutting tools 6 x 6 x 60 mm of especially hardened steel. Rough cutting tool, right Interior turning tool, 130 mm
€14.90 *
Offset wrench for torx for cutting tool holder 41623-M and 41623-S.
€2.90 *
Turning tools with carbide indexable inserts Dimension 8 x 8 mm suitable for all lathes Length 60 mm, each in the 3 forms, delivery per 1 piece, please select: finishing tool Side steel right - SOLD OUT Side steel left
€34.90 *
Turning tool, with replaceable tungsten carbide tip. Picture shows all 3 varieties. Diameter 6 x 8 mm for your UNIMAT 3 and UNIMAT 4 Length 60 mm. Turning tool, neutral - Turning tool, right hand - Turning tool, left hand Delivery one...
€34.90 *
Offset wrench for Torx T8. For our turning tools 41617-41619 and 41717-41719.
€2.90 *
Viewed